Search results

sad to see it go, but now listed on ebay. Honda civic b18c6 facelift ek ej9 ek9 b18 b16 | eBay

Few bits have been happening, fancied some s2000 clocks. So went a head and went for the ap1 clocks and got the converter module and started the install. I also went ahead and got a snap of steering wheel with boss. Steering wheel was a 330 momo, the snap of boss has a key system to remove...

took it out the box, and found this. when i touch the cable cable to the metal on the board. speed still does not change? any ideas?

yer seen that, cheers. searched for hours

Speedo isn't working, was but then stopped. Anyone got any ideas? waiting for a mate to test the converter box by checking the in and out current with a volt meter. Its not the clocks, tried 2 sets. not a fuse. checked every single one. Anyone got any other ideas?

I got the surround all done, fixed the hazards (fuse). They now work!! just trying to work out why the speedo stopped working. Strange.

yer done it this morning, looks ok! just got to sort out why the speedo stopped working and the hazards don't work. Everything else is spot on.

clocks where fine, then i took them out and back in and the clocks speed stays at 0. any ideas? wiring is fine

anyone?

Many people put them in there ek? putting them in my ej9 over weekend hopefully. What have people done about the clock surround/fitment?

pm'd few of you, any genuine spoon spoilers?

any thing?

350 wheels, 150 spoiler

After some wheels, 15 4x100 for my ej9 civic. As well as a spoiler, ek9, spoon etc.

sorted it cheers

Question for anyone, fitting a aftermarket steering wheel and the boss uses a metal contact from the horn wire on the rear of it.(something you have to create) this in turn should make the horn sound when the horn button is pressed due to there being a wire inside the boss leading to the...

Aftermarket steering wheel, I have a snap off boss going into a OMP steering wheel. I can't get the horn to work, the wire inside of the boss is connected to the steering wheel. I tried touching a wire onto the back of the metal boss and it just goes off on me? I was going to create something...

Need to still do the rear brakes! I have also sprayed the side mouldings silver. I have also treated myself to a steering wheel with snap off boss, pics to follow :) Also have got a jordan lip to spray and fit.

So big update, photos aren’t great. Recently I crashed the blue preface lift ek3, which had loads of rust etc. So I told myself a re-shell was in order. I ideally wanted a ek9 shell but the cost was too much for me. So I went for facelift ej9. This is where the work all started, wanted it...