Best off just converting an ek9 p/s to fully manual
whats the best way to do this? ive heard of pumping it with grease, looping the feed and return, but what is the proper way to do it so it will last and will pass nct as if they see it is meant to have p/s and you,ve just looped the lines they wont pass it!Its just a fully manual rack and is very hard to get 2nd hand.. best off just converting an ek9 p/s to fully manual
The EK9 non PAS rack is not a quick rack like the normal 9 rack. It's just taken from a bottom of the range non PAS EK Civic.
IMO best off converting a normal 9 rack.
Dunx
Strip down the rack and cut the sealing piston off the centre of the rack ..
This is what I did to mine. After doing this just cut off the plugs for the line on the rack, weld them in and you are good.
To do this did you take the big nut off the nearside of the rack?