Dias
New Member
- Joined
- Apr 29, 2008
- Messages
- 54
Ok after doing tons of searching about the whole 5-lug 32mm and 36mm axle thing I have a simple question
I have 2 sets of 5-lug brakes I was told one set was USDM ITR and the other was JDM ITR.
So I took my old LS integra axle and put it in the both 5-lug setups,both spindles on both of the 5-lugs seem to take the axle in just fine.
My ? is if one of my setups was in fact the 36mm JDM spec 5-lug,my 32mm axle would not even fit the hub- I.E. 32mm and 36mm refer to the spline count and not the length of the actual axle itself.
any info would be great!
cheers!
I have 2 sets of 5-lug brakes I was told one set was USDM ITR and the other was JDM ITR.
So I took my old LS integra axle and put it in the both 5-lug setups,both spindles on both of the 5-lugs seem to take the axle in just fine.
My ? is if one of my setups was in fact the 36mm JDM spec 5-lug,my 32mm axle would not even fit the hub- I.E. 32mm and 36mm refer to the spline count and not the length of the actual axle itself.
any info would be great!
cheers!