Kipper
Well-Known Member
- Joined
- May 27, 2008
- Messages
- 2,163
Alright guys, I have bought a Mugen intake recently from Jap performance parts, it was removed from a DC2 apparently, even has a sticker on it from when it was removed confirming it was from a DC2.
But being a Gen.1 I can find very little info on it, and teh internetz is luring me towards the fact I have an EK9 intake. So anyone know/confirm if these are the two bolt holes that the gen.1 one uses to mount onto the chassis because this is where mine should line up after some ghetto measurements. I'm beginning to believe that the gen.1 intake for the DC2 is a myth after more research?
My shield is similar to this.
My intake.
Any help is appreciated, I would try and fit it, but I have fitted a Gen.2 on my dads DC2 and there is a bit of work would rather find out if I have the right intake first.
Kris
But being a Gen.1 I can find very little info on it, and teh internetz is luring me towards the fact I have an EK9 intake. So anyone know/confirm if these are the two bolt holes that the gen.1 one uses to mount onto the chassis because this is where mine should line up after some ghetto measurements. I'm beginning to believe that the gen.1 intake for the DC2 is a myth after more research?
My shield is similar to this.
My intake.
Any help is appreciated, I would try and fit it, but I have fitted a Gen.2 on my dads DC2 and there is a bit of work would rather find out if I have the right intake first.
Kris