Mugen N1, Inlet Man, M factory, Distributor, Other


K

kiwi

Member
Joined
Mar 31, 2009
Messages
231
Clearout of all my remaining unused ek9 parts. Open to offers on most of it as its just gathering dust. All prices plus postage.

Description; Mugen N1 ECU. Will lower the VTEC to around 4200 rpm and raise the rev limiter to 9100rpm. Only being removed due to runing on throttle bodies and purchase of aftermarket ECU. Direct fit fo the pre-facelift OBD2a or others with a conversion harness. Upgraded valve springs are recommended only due to higher redline. Cost a fortune new.

Price; SOLD

Location; Brigdend, South Wales Junc 36 M4

Condition; Perfect

16p5pk.jpg

n1fo1d.jpg



Item for sale: M Factory 1.21 5th Gear
Price: £200
Location: Bridgend, South Wales
Condition: Used. Only done 2-300 miles
Description: 1.21 ratio 5th gear. Purchased from Des Moore Race and Rally in January this year, removed and changed for a different ratio.


Item for sale: EK9 Distributor
Price:SOLD
Location: Bridgend, South Wales
Condition: Used. Only done 2-300 miles
Description: Purchased for my rally car new. Now runing coilpack so no longer required. Done around 400 miles. Has the square fitment plug seen in photo.

5nozmd.jpg



Item for sale: MAP Sensor
Price: £20
Location: Bridgend, South Wales
Condition: Used.
Description: Runing aftermarket Management so no longer required. Perfect working order when removed.

2yngwic.jpg



Item for sale: Idle Control Valve ICV
Price: £20
Location: Bridgend, South Wales
Condition: Used.
Description: Runing aftermarket Management so no longer required. Perfect working order when removed.

4hzt.jpg



Item for sale: oe 1st 3rd, 4th and 5th gears
Price: Offers
Location: Bridgend, South Wales.
Condition: Used
Description: After fiting a mfactory close ratio gearset i have the following standard ek9 S4C gears for sale. All gears were fine before removal and look in good condition. 3rd 4th and 5th come in pairs. 1st only have the secondary shaft gear (large one).

99miw3.jpg



Item for sale; ek9 Power steering pump, (Think fits all B series)
Price; £20
Location; Bridgend, South Wales
Condition; Used
Description; Removed from engine/gearbox combo i bought. Surplus to requirement.

2it4pya.jpg
 
Last edited:
Can the ecu be used with a B18 bottom end B16 head setup?

Dale.
 
do you know whether the power steering pump can fit d-series?interested in that
 
Dale10ellis10 said:
Can the ecu be used with a B18 bottom end B16 head setup?

Dale.
Click to expand...

The ECU is best suited to 1600cc bottom end as thats what its been setup for by Mugen. It will run on 1800 bottom end but wont give you the best performance.
 
how much you looking for the 4th and 5th gears? can pay today.
 
£20+postage? Id rather you just told me a price mate so if its decent i can just pay and have these sent out rather than ****ing about like this.
 
If you have still got the dizzy can I please have it.
Thanks Duncan
 
hey dude i know this is an ancient thread so i appologise for bumping, do you still have this inlet knocking about?? im from swansea and can collect any time, cheers tom
 
Since this has already been bumped, I assume the ecu has been sold?
 
You must log in or register to reply here.
Back
Top