My shitty EK !


EK_Billy

New Member
Joined
Feb 15, 2012
Messages
4
Yooo, new to this site, from Ipswich area, got my ek about 4 months ago, its been very reliable considering its on 145k lol. Not new to modifying really, My old car was a 306 5 door on coilovers, with a comic book strip boot and chalkboard roof with a gamecube haha, piece of crap! But yeh now got the 1.4 16v, havnt got alot of money until april when i start my new job, so its only had cheap ass mods. I plan to spray it Matt white, on some Type R alloys powder coated red or purple, Tow hook for the rear and more lows on the front and rear.

So far:

Straight through Jap can, loud as F**K and annoying me! :(
Traditional stickers on the rear window lol
Carbon wrapped fuel flap
Coilover sleeves, but rear is way way to high :(
Sus-tec strut brace
Straight through cold air feed from bumper to throttle body
TRS tow strap
Comic book- carbon wrap grill

So yeh hate away guys :p

DSCN0445.jpg

DSCN0446.jpg

DSCN0447.jpg

DSCN0448.jpg

DSCN0449.jpg

DSCN0450.jpg



and my old pug lol:

be9ac22b.jpg

bc01d929.jpg

1d8622cc.jpg

b4fb122a.jpg

baf3da78.jpg
 
You put the cold air feed in the wrong place :( Civic isn't too bad but pug is ugly as **** in my opinion
 
don't like the cold air feed atall, plus isnt the airbox the other side?

has potential
 
Haha, mixed response, i like to be errr, different ;)

the quickest and strightest route for the cold air feed is over the dipstick as the otherside the rads in the way, its a squeeze, but it works, need to mesh it up somewhere to stop leaves etc going straight through :)

Took front plate and surround off the otherday, looks a million times better. Its a cheap run around, just cant wait to deck it :D
 
dude, did you not think to put it on the corner of the bumper? thats the logical place to put it. no rad there
 
Back
Top