Bit of an update on this 1 !
Picked up a few nice parts lately.
firstly i decided to remove the X brace an sell up. So that's prov sold with a deal on spoiler tilt brackets which i should have tuesday. Bought new rear plastics to freshen up the boot. No more holes.
Next on the list was a spoon N1 after seeing in on a few 9's on here. Bought it off an ek9 but as some of you might have seen it does not fit for some reason. Im undecided of what to do with it but will get a thread up later to get your opinions.
With spoon on the brain i went about getting a set of super low rails. Fitted the drivers side 1 so far an f**c me there like sitting on the floor. Undecided of what to do with them yet because im not the tallest of young-felas.
The car is now half off the road while i get a few things sorted. Driving a wee starlet for the time being
Plans now are to get the whole car gleaming both inside and out as the seats alone are a disgrace
the rear is all stripped and should begin the cleaning early morning.
Also due a good service among a few other vtec goodies
A selection of pictures to keep ye all busy.
All comments are welcome
The run-about
Difference in seat position before the valeting
Spoon N1
Some rails
A rocker cover i have done for the engine
All pictures were taken off my phone so excuse the quality
