what does this mean ??


limezy2

limezy2

civic ek4 1.6l
Joined
May 28, 2010
Messages
18
B18c swap - what car is this from / where could i get it
B16b Stroker kit - car it's from and what is a stroker kit
B20 swap - what car this were avaiable
Turbo B16/18/20
High comp B16/18/20
Supercharged B18
 
lol you have alot of question there, a b18c is an engine from a jdm type r integra put into your ek. very good swap, cost bout 2000. you need b18c engine, box, ecu. i think your mounts and drives will do.
a b20 in the bottom end taken from a honda crv (i think) which can be used with you head to turn you car into a 2litre monster lol. some modifications are needed for this swap. cost, not too sure. need b20z bottom end, crank, rods, pistons, have the block tapped for oil, programmable ecu, maybe mounts( i dont know) other will tell you exactly like ek9turbo, vtec6000, blinx etc etc..
wel i thinking turbo/supercharging are self explanatory in a sense. the idea is the same but to do it right is a bit different. it alls depends on what you wnat from the car. whether it is a 300bhp pocket rocket or an all out monster your needs will change. cost, expensive. alot of mods needed. turbo, manifold, inteercooler, dumpvalve, wastegate, injectors, mappable ecu, rods, pistons, head studs, rod bolts, oil catch can, oil/water lines,would want uprated crank/rod/bearings. the list goes on
this is not the best answer to your questions but maybe an idea.
 
cheers for that yeah i got what that went however what is a stroker kit / purpose and hp increase if any aprox
 
How to Tie Your Shoe​

You will need:

1. A shoe.
2. A pair of shoe laces.
3. A pair of hands.

Procedure:

1. First you take one shoe, and lace it up with your shoelace.

2. To lace it up, criss cross your shoelace over and under the holes in your shoe.

3. When the ends of your shoelaces meet take one end, lay the other down, then go over and under your laid down end.

4. Take one end of your shoelace and make a loop.

5. Take the other shoelace and wrap it around the loop.

6. By doing that, you will make a smaller loop.

7. Put the middle of the shoelace you haven't looped, through the small hole.

8. By putting your shoelace through the hole, you make another big loop.

9. Pull on the big loop very hard, this will make it tight.

10. That's how you tie your shoe!
 
Championship White said:
How to Tie Your Shoe​

You will need:

1. A shoe.
2. A pair of shoe laces.
3. A pair of hands.

Procedure:

1. First you take one shoe, and lace it up with your shoelace.

2. To lace it up, criss cross your shoelace over and under the holes in your shoe.

3. When the ends of your shoelaces meet take one end, lay the other down, then go over and under your laid down end.

4. Take one end of your shoelace and make a loop.

5. Take the other shoelace and wrap it around the loop.

6. By doing that, you will make a smaller loop.

7. Put the middle of the shoelace you haven't looped, through the small hole.

8. By putting your shoelace through the hole, you make another big loop.

9. Pull on the big loop very hard, this will make it tight.

10. That's how you tie your shoe!
Click to expand...

:lol: :lol: :lol:
 
You must log in or register to reply here.
Back
Top