RagingAngel
本田 Gearing Authority
- Joined
- Mar 26, 2008
- Messages
- 2,161
hye guys....
i'm planning on building b20 engine....
my current engine is b16b...
here's the stuff :
1.skunk2 pro series stage 3 cam+valve spring+retainer (complete cam stuff)
2.porting & polish head
3.CRV block with 85mm wiseco or supertek forged piston
4.h22a injector
5.Aem/toda adjustable cam pulley
8.2.5" piping
Is there's anything that i need to add?
i need your comment on this
I would go with at least 70mm/2.75in piping or 3.0 in exhaust if you're going to run that much cam and compression. You'd better have a good header too - though the hytech copies will be ok since most are the copies of the 2.0L big tubes from back in the day.
Forget the AEM "Tru-Slips" go with Toda for reliability. The last thing you want is for the camgear to slip and you make piston to valve contact or valve to valve contact ruining your entire motor.
Go for an injector that's at least 440cc.
what max hp can 0bd2 h22a 280cc take?
is it worth getting the complete engine rotating assembly done?
Realistically, without bumping the base fuel pressure to stratospheric levels, you could probably get away with 220bhp. Consult your tuner and trust in his ability to guide you appropriately.
Some like to run a smaller injector and high fuel pressure vs. a large overall injector.