Two builds at once must be tough ! I'm planning to remove the underseal on my car also.. been putting it off for too long. Did you use a grinder with wire brush? I hope to get my underbody down to bare metal, treat any bits of rust, use zinc primer also and then paint it original red colour to match car but im afraid it wont last ?
Yes mate i used a high rpm grinder with twist and knot wirewheel, if you do go down the same dont use any of the cheap wirewheels youl end up wasting your time, im going to stonechip mine white and clear coat with enamel, i was going to paint it gloss white but it definitely wouldn't last on these roadsTwo builds at once must be tough ! I'm planning to remove the underseal on my car also.. been putting it off for too long. Did you use a grinder with wire brush? I hope to get my underbody down to bare metal, treat any bits of rust, use zinc primer also and then paint it original red colour to match car but im afraid it wont last ?
Thanks mate its taken alot of time and effort but once its done itl surely be worth itHats off to you for this mate... one day ill be in the same boat soon as i get a unit!
That underside in primer is the money shot